3 Series E91 325xi (N52K) TOUR
•
Remove injection pipe and place to one side
Release A/C compressor (1) and set down on front axle carrier.
Note:
E60/E61 only.
Important!
A/C lines are pressurized.
Do not disconnect A/C lines.
Do not disconnect coolant pipe from crankcase.
Release power steering pump (1) and set down on front axle
carrier.
Note:
Do not disconnect hydraulic lines.
Note:
For vehicles with optional extra SA229 (Dynamic Drive), bracket
must be released.
Screw towing eye (1) into cylinder head.
Tightening torque 11 12 9AZ
.
Suspend special tool 11 0 020 from engine crane.
Suspend special tool 11 0 020 from the designated mounting
eyelets (2) only.
Lift engine out with engine crane.
Note:
For vehicles with optional extra SA205 (automatic transmission),
engine must be raised approx. 10 cm.
Release screws (1).
Remove lines (2) with oil-water heat exchanger in direction of
arrow.
RA Removing and installing engine (N52K)
BMW AG - TIS
11.02.2013 09:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
