3 Series E91 325xi (N52K) TOUR
Installation:
Adjusting screw (2) must not be missing or damaged, replace if
necessary.
Replace white slide elements (1).
Replace slide elements (3).
The correct slide elements (3) must be fitted, depending on the
rear lid build date (see next work step).
-
Build date up to 09/2005 M7 black slide nut
-
Build date from 10/2005 M8 gray sliding piece
Build date up to 09/2005:
In case of rear window with hole (1), clip (2) and M7 slide
nut (3) must be fitted on left and right.
Clip (2) and M7 slide nut (3) must be replaced.
When replacing rear window/rear spoiler:
Clips (2) and slide nuts (3) must be adapted to existing build
date of rear window.
Build date from 10/2005:
In case of rear window with elongated hole (1), expander
element (2) and M8 sliding piece (3) must be fitted on left and
right.
Expander element (2) and M8 sliding piece (3) must be
replaced.
When replacing rear window/rear spoiler:
Expander element (2) and slide nuts (3) must be adapted to
existing build date of rear lid.
Observe installation sequence:
1.
Tighten down screws (1)
Tightening torque, 51 71 1AZ
.
2.
Adjust rear spoiler (see next work step)
3.
Tighten down nut (3)
Tightening torque, 51 71 1AZ
.
4.
Secure expander rivets (2)
Make sure expander rivets (2) are correctly seated
RA Removing and installing rear spoiler
BMW AG - TIS
11.02.2013 20:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
