3 Series E91 330d (M57T2) TOUR
Pull out service cover (1).
Unlock and disconnect quick-release fastener (3) of fuel feed
line.
Installation:
Clean sealing faces and install new rubber seal (2).
Locating rods (4) must fit correctly in the hole (5) of the delivery
unit.
Make sure that the lever sensor moves freely before fitting the
service cap (1).
Installation:
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
Disconnect line (1) towards top
Unlock quick-release fastener (3) and detach fuel return line (2).
Important!
Do not use any tools to release the fuel feed line.
Draw off remaining fuel from surge chamber.
Carefully lift fuel pump with fuel level sensor (4) out of fuel tank.
RA Removing and installing / replacing fuel pump (diesel)
BMW AG - TIS
17.02.2013 19:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
