3 Series E91 330d (M57T2) TOUR
11 22 513
Replacing roller bearing for dual-mass
flywheel
Special tools required:
•
23 4 031
•
23 4 033
•
23 4 035
•
23 4 036
•
23 4 040
Necessary preliminary tasks:
•
Transmission removed.
•
Remove clutch release bearing
Pressing out roller bearing:
Install special tool 23 4 031 in front of drive shaft spline teeth.
Screw in grease spindle 23 4 033 completely.
Brass tip must immerse fully into roller bearing.
Press in grease with grease gun 23 4 040 until roller bearing is
disengaged from drive shaft.
Remove special tool 23 4 031 .
Remove pressed-in grease (1) from drive shaft completely.
Then reinstall special tool.
RA Replacing roller bearing for dual-mass flywheel
BMW AG - TIS
17.02.2013 19:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
