3 Series E91 330d (M57T2) TOUR
Position an oil tray underneath to catch brake fluid.
Release banjo bolts (1), gripping brake hoses (2) at square
head in the process.
Disconnect brake hoses (2) and seal off with plugs.
Installation:
Make sure brake hoses are laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 34 32 1AZ
.
Unclip cables for pulse generator and ride-height sensor/brake
pad sensor on rear axle carrier at side.
Slacken nut (1).
Turn bracket (2) for exhaust system towards rear.
Release sheet nut and bolts (arrows).
Place heat shield on exhaust system.
Warning!
Danger to life!
Car may tilt off lifting platform if the workshop jack is
incorrectly handled.
After supporting components, make sure that:
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
RA Lowering/raising rear axle carrier (universal lifter)
BMW AG - TIS
18.02.2013 01:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
