3 Series E91 330d (M57T2) TOUR
Mark severance cuts in accordance with specified measurements and cut.
Important!
Cut outer metal sheet only.
Measurement a = 220 mm from roof edge
Measurement b = approx. 90 mm from middle of lower lock striker screw point.
Measurement c = approx. 150 mm from roof frame
Open weld joints in areas (1).
Installation information:
-
Apply window glass adhesive to cavity acoustic baffles (2).
-
Weld in reinforcement plates at severance cuts.
Open weld joints in areas (1).
Open brazed joint in areas (2).
Installation:
When adjusting new part to fit, cut off tabs (2) of reinforcement
on both sides of severance cut (1).
RA Replacing rear left side panel (partial replacement before longitudinal member c
BMW AG - TIS
18.02.2013 03:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
