3 Series E91 330d (M57T2) TOUR
54 13 130
Removing and installing front cross-member
Necessary preliminary tasks:
•
Remove glass slide/tilt sunroof
•
Remove control unit for glass slide/tilt sunroof
•
Remove drive
Release screws in marked area.
Tightening torque: 54 12 03AZ
.
Feed cross-member (2) out of wiring harness (1) during
removal.
If necessary, release fabric adhesive tape and replace.
Installation:
Pitch cables must be correctly located in guide
RA Removing and installing front cross-member
BMW AG - TIS
18.02.2013 07:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -