bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

2 RA Removing And Installing_replacing Drive With Gear (rear) For Actuating Slide_til|Page 2757 > < 2 RA Removing And Installing_replacing Drive With Gear (rear) For Actuating Slide_til
Page 2
background image

Important!

Do not kink roofliner under any circumstances!

 

Pull off muckets of rear lid and rear doors in roof area.

Unclip roofliner (1) in middle area downwards and lower.

Installation:

Holder (2) for roofliner (1) must be replaced.

Disconnect plug connection (1) and if necessary expose cable.

Release screws (2) and remove drive (3).

Tightening torque 51 13 1AZ

.

Installation:

Insert gear wheel (1) of drive with gear for actuating slide/tilt
sunroof (2) exactly in gear teeth (3).

Installation:

Initialize slide/tilt sunroof.

RA  Removing and installing/replacing drive with gear (rear) for actuating slide/til

BMW AG - TIS

18.02.2013  11:49

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

2 RA Removing And Installing_replacing Drive With Gear (rear) For Actuating Slide_til|Page 2757 > < 2 RA Removing And Installing_replacing Drive With Gear (rear) For Actuating Slide_til