3 Series E91 330xi (N52) TOUR
•
Remove fuel injector rail and place to one side.
Release A/C compressor (1) and set down on front axle carrier.
Important!
A/C lines are pressurized.
Do not disconnect A/C lines.
Do not disconnect coolant pipe from crankcase.
Release power steering pump (1) and set down on front axle
carrier.
Note:
Do not disconnect hydraulic lines.
If Dynamic Drive optional extra is fitted, release bracket.
Screw in towing hook (1).
Suspend special tool 11 0 020 from engine crane.
Suspend special tool 11 0 020 from the designated mounting
eyelets (2) only.
Lift engine out with crane.
Note:
If automatic transmission optional extra is fitted: Raise engine
approx. 10 cm.
Release screws (1).
Remove lines (2) with oil-water heat exchanger in direction of
arrow.
RA Removing and installing engine (N52)
BMW AG - TIS
20.02.2013 22:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
