3 Series E91 330xi (N52) TOUR
Installation:
Service cap can only be installed in one position.
When installing, make sure lug (1) of service cap engages in
corresponding opening (2) on fuel tank.
Make sure that the lever sensor moves freely before fitting the
service cap.
Clean sealing faces and install new seal.
Attach an auxiliary lead (1) to hose pack (2) through service
opening.
The auxiliary lead is pulled through with the hose pack towards the
left and facilitates subsequent reinstallation.
Installation:
Make sure when pulling through the hose pack that the tank
ventilation system in the tank tunnel is not damaged.
Carefully lift sensor unit (1) out of tank.
In so doing, press tab (2) against spring force in order to make it
easier to feed sensor unit out of tank.
Note:
Illustration shows the tank removed.
Remove sensor unit (1) and hose pack (2) with auxiliary cable to
left.
Installation:
When replacing the sensor unit, modify the end of the auxiliary
lead to the new hose pack and carefully pull in through the tank.
Note:
Illustration shows the tank removed.
RA Removing and installing or replacing fuel gauge sensor (petrol/gasoline, left)
BMW AG - TIS
21.02.2013 01:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
