3 Series E91 330xi (N52) TOUR
Release nut and remove clutch slave cylinder.
Installation:
Tightening torque 21 52 5AZ
.
Important!
N47 with H-transmission only
Clutch slave cylinder must not rest at the side on the
transmission.
Failure to comply with this instruction may result in leaks at
the clutch slave cylinder.
Installation:
Clean thrust member (1) and contact face on release lever
(2).
Lightly grease thrust member (1) on contact face (3).
Grease, refer to BMW Service Operating Fluids.
Important!
Spacer between fuel line and pressure hose of clutch slave
cylinder must be correctly fitted.
RA Removing and installing or replacing clutch slave cylinder
BMW AG - TIS
21.02.2013 01:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
