3 Series E91 330xi (N52) TOUR
Installation:
When installing, do not damage shaft seal and bearing.
If the torque converter is not correctly installed, the driver of the
pump impeller may be damaged when the transmission is flanged
to the engine.
Remove torque converter and set down vertically.
Installation:
Push torque converter through shaft seal onto transmission shaft
as far as it will go.
Press torque converter by hand into converter housing and turn in
the process. Converter hub opening must snap into place in driver
of pump impeller. Torque converter must be felt to slip inwards.
RA Removing and installing/replacing torque converter (GA6HP19Z)
BMW AG - TIS
21.02.2013 02:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
