3 Series E91 330xi (N52) TOUR
31 12 090
Removing and installing/replacing both
compression struts (AWD)
Special tools required:
•
31 2 240
•
31 2 242
•
31 2 246
Note:
If the compression strut is detached from the front axle carrier, it is
necessary after reinstallation to carry out a wheel/chassis
alignment check.
Replace both compression struts in event of hydro-mount
damage.
Necessary preliminary tasks:
•
Remove guide joint on both sides from swivel bearing
•
Remove reinforcement cover
Unscrew nut (1).
Remove screw (2) to one side and remove compression strut (3)
with guide joint.
Installation:
Replace self-locking nut.
Tighten bolt connection in normal position.
Tightening torque 31 12 5AZ
.
RA Removing and installing/replacing both compression struts (AWD)
BMW AG - TIS
21.02.2013 03:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
