3 Series E91 330xi (N52) TOUR
31 31 003
Removing and installing complete front left or
right spring strut (AWD)
Special tools required:
•
31 2 230
•
31 5 220
Important!
If the centering pin is missing from the support bearing, the
position of the studs to the wheel arch must be marked so that
the original camber is approximately maintained.
Only one nut may ever be released for marking.
Necessary preliminary tasks:
•
Remove brake disc
•
Remove stabilizer link from spring strut
•
Remove tie rod end from swivel bearing
•
Remove guide joint from swivel bearing
•
Remove control arm from swivel bearing
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
RA Removing and installing complete front left or right spring strut (AWD)
BMW AG - TIS
21.02.2013 03:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
