3 Series E91 330xi (N52) TOUR
32 21 231
Replacing (removing and installing) left or
right tie rod
Important!
The steering gear must be replaced if the polished surface of
the rack is damaged (e.g. by corrosion)!
Necessary preliminary tasks:
•
Remove tie rod end from swivel bearing
•
Remove gaiter from steering gear and slide back
Important!
To avoid damage to rack and to suspension mounting, move
rack in as far as possible.
Release joint (1) with standard tool (38 WAF) from steering gear
rack.
Tightening torque 32 21 1AZ
.
Installation:
Clean rack.
Check surface of rack for damage (e.g. corrosion).
Power steering gear only: Grease rack (refer to BMW Service
Operating Fluids).
RA Replacing (removing and installing) left or right tie rod
BMW AG - TIS
21.02.2013 04:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
