3 Series E91 330xi (N52) TOUR
32 41 332
Replacing pressure line for power steering
(N51, N52, N53 AWD)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove front underbody protection
Release banjo bolt and detach pressure line from vane pump.
Installation:
Replace all sealing rings.
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 8AZ
.
RA Replacing pressure line for power steering (N51, N52, N53 AWD)
BMW AG - TIS
21.02.2013 04:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
