3 Series E91 330xi (N52) TOUR
32 41 250
Removing and installing/replacing fluid
reservoir for power steering
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
N45, N46, M47T2:
•
Remove intake duct if necessary with gaiter
M57T2 335d:
•
Unclip coolant hose on coolant expansion tank
Release screw (1).
Tightening torque 32 41 1AZ
.
Note:
If necessary, raise and/or turn fluid reservoir in order to gain better
access to hose clamps.
Unfasten hose clips.
Disconnect suction line and radiator return line from fluid reservoir.
Lift out fluid reservoir.
RA Removing and installing/replacing fluid reservoir for power steering
BMW AG - TIS
21.02.2013 04:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
