3 Series E91 335i (N54) TOUR
Installing new rubber mount:
Insert rubber mount with spray-on points facing upwards in special
tools 33 4 451 , 33 4 452 , 33 4 454 , 33 4 453 and pull
together.
Insert rubber mount in special tool 33 4 473 .
Important!
Spray-on points of rubber mount must point to rear!
Align rubber mount by way of slot (1) at an angle to wheel carrier.
Draw rubber mount with special tools 33 4 465 , 33 4 466 ,
33 4 475 , 33 4 474 and 33 4 473 a little into wheel carrier.
Remove special tool 33 4 450 and draw in rubber mount as far
as it will go.
After installation:
•
Carry out wheel/chassis alignment check
RA Replacing rubber mount for trailing arm in wheel carrier
BMW AG - TIS
23.02.2013 08:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
