3 Series E91 335xi (N54) TOUR
Release screw.
Tightening torque 17 21 2AZ
.
Detach oil line (1) from engine oil cooler flange.
Catch and dispose of emerging fluid.
Installation:
Replace sealing rings.
Unfasten screws.
Unscrew nuts (1).
Tightening torque 17 21 3AZ
.
Release screw (2).
Tightening torque 17 21 4AZ
.
Feed out engine oil cooler (3) and remove.
Note:
After completing work, check engine oil level and top up if
necessary.
RA Removing and installing/replacing engine oil cooler (N54)
BMW AG - TIS
23.02.2013 15:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -