3 Series E91 335xi (N54) TOUR
Remove insert nut (1).
Installation:
Insert nut must be replaced.
Before installing propeller shaft:
Clean insert collar (1) on flange nut and spline teeth on bevel
pinion (2).
Fill insert collar (1) with grease.
Grease: BMW Service Operating Fluids.
Clean thread (1) of joint hub to remove adhesive residues.
Clean hub teeth (2), then coat with grease.
Grease: BMW Service Operating Fluids.
Important!
Thread of joint hub must not be fouled with grease.
Place insert nut (1) with seal in insert collar of flange nut.
Install retaining clip (2).
RA Removing and installing propeller shaft (inserted) completely
BMW AG - TIS
23.02.2013 16:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -