3 Series E91 335xi (N54) TOUR
54 13 150
Removing and installing rear cross-member
Necessary preliminary tasks:
•
Remove glass slide/tilt sunroof
•
Remove control unit
•
Remove drive
Release screws in marked area.
Tightening torque: 54 12 03AZ
.
Feed cross-member (2) out of wiring harness (1) during
removal.
Installation:
Pitch cables must be correctly laid diagonally in guide.
RA Removing and installing rear cross-member
BMW AG - TIS
24.02.2013 00:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -