3 Series E92 316i (N43) COUPE
Screw special tool 11 9 232 with screws (special tool
11 9 234 ) to crankshaft.
Note:
Support sleeve (1) is supplied with crankshaft seal (2).
When crankshaft seal (2) is installed, only support sleeve (1)
may be used as a slip sleeve.
Crankshaft seal (2) has a groove on both left and right sides.
Important!
After installation, the grooves must be filled with sealing
compound.
Note:
The required parts are available from the BMW Parts Service
(Electronic Parts Catalogue ETK).
Remove screw caps (1) from injector (2).
Screw on needle and insert plunger.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
Push support sleeve (1) with crankshaft seal (2) onto special
tool 11 9 232 .
Important!
Support sleeve (1) remains on special tool
11 9 232 , until
crankshaft seal is drawn in.
Align groove (3) centrally to housing partition (4).
Coat both grooves (3) on crankshaft seal (2) with Loctite primer,
manufacturer's number 171000, and expose to air for approx.
one minute.
RA Replacing front crankshaft seal (N43)
BMW AG - TIS
20.01.2013 09:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -