3 Series E92 316i (N43) COUPE
Release screws (1).
Tightening torque: 11 41 2AZ
.
Release screws (1).
Important!
Balancing shaft oil pump unit (3) must be held in place by a
second person before screws are released.
Tightening torque: 11 27 1AZ
.
Note:
Chain tensioner (7) of oil pump chain is secured with a locating
pin (6).
When removing balancing shaft oil pump unit (3), make sure
locating pin (6) is not tilted.
Lift balancing shaft oil pump unit (3) off crankcase until adapter
sleeves is no longer secured.
Remove balancing shaft oil pump unit (3) towards rear.
Note:
Picture shows N46T.
RA Removing and installing/replacing oil pump with balancing shafts (N43)
BMW AG - TIS
20.01.2013 10:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
