3 Series E92 325xi (N53) COUPE
Release aluminium screw on right (1) on right next to cable
retaining plate with special tool 00 9 010 .
Blue aluminium screws/bolts must be replaced.
Tightening torque 24 00 2AZ
.
Insert special tool 24 1 370 into opening of transmission
housing and secure with screw (1).
Note:
Note installation position.
Lug (2) must point in opposite direction to direction of travel!
Supporting transmission:
Support with special tools 23 4 050 , 23 0 132 and 00 2 030 .
Secure transmission with tensioning strap (1).
Tasks are described in Transmission bracket.
After completion of work, check transmission oil level.
-
Remove transmission cross-member
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
RA Removing and installing automatic transmission (6HP19Z) N52/N53 AWD
BMW AG - TIS
28.01.2013 02:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
