3 Series E92 325xi (N53) COUPE
25 11 111
Replacing shift rod joint
Necessary preliminary tasks:
-
Release propeller shaft at transmission and centre mount.
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
-
Remove transfer case (AWD)
Lift off retainer (1).
Disconnect shift rod (2).
Installation:
Grease shift rod.
Grease, refer to BMW Service Operating Fluids.
Make sure shims (3) are in correct position.
Lever spring washer (1) out of groove and push a little towards
rear.
Press dowel pin (2) upwards/downwards out of shift rod joint and
remove shift rod joint.
Installation:
Grease ball of selector shaft.
Grease, refer to BMW Service Operating Fluids.
Replace spring washer (1).
RA Replacing shift rod joint
BMW AG - TIS
28.01.2013 02:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
