3 Series E92 325xi (N53) COUPE
If necessary, screw nut (1) onto guide joint by a few turns.
If necessary, replace lower section 31 2 242 with lower
section 31 2 246 .
Press guide joint with special tool 31 2 240 out of compression
strut.
Unscrew nut (1) and remove guide joint.
Installation:
Keep journal on guide joint and bushing in compression strut
clean and free from oil and grease.
After installation:
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
RA Removing and installing/replacing both compression struts (AWD)
BMW AG - TIS
28.01.2013 03:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
