3 Series E92 325xi (N53) COUPE
Release clamping screw.
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
No kinking permitted!
Tightening torque 32 31 4AZ
.
Release clamping screw (1).
Return steering to straight-ahead drive setting and remove ignition
key.
Pull steering spindle lower section (3) from double joint (4).
Installation:
Clean thread to remove all remnants of screw securing adhesive.
Replace clamping screw.
Clamping screw must rest in groove (2) of steering spindle lower
section (3).
No kinking permitted!
Tightening torque 32 31 4AZ
.
Detach lower section of steering spindle from steering column.
Installation:
Lower section of steering spindle can only be attached in one
position to the steering column.
After installation:
•
Turn steering wheel in both directions to full lock. The airbag
warning lamp must not light up in the process.
•
Carry out steering angle sensor adjustment
•
Check directional stability of car
RA Removing and installing/replacing steering spindle lower section (AWD)
BMW AG - TIS
28.01.2013 04:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
