3 Series E92 325xi (N53) COUPE
Important!
Cut outer plate only for following severance cuts.
Measurement a = approx. 130 mm from edge of rectangular hole.
Measurement b = approx. 160 mm from centrepoint of 12 mm dia. bore.
Open weld joints in areas (1).
Installation:
Weld in reinforcing panels at all severance cuts.
Apply window glass adhesive to cavity acoustic baffles (2).
Mark severance cuts in accordance with specified measurements and cut.
Important!
Cut outer plate only for following severance cuts.
Measurement a = approx. 150 mm from roof edge.
Measurement b = approx. 80 mm below severance cut a.
Measurement c = approx. 500 mm before hole dia. 20 mm.
Open weld joints in areas (1).
Installation:
Sheet panel (2) is needed again to seal cowl.
RA Replacing front left door pillar (front side panel removed)
BMW AG - TIS
28.01.2013 07:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
