3 Series E92 328i (N51) COUPE
11 22 500
Removing and installing or replacing flywheel
(N51)
Special tools required:
•
11 4 180
•
11 9 260
•
11 9 265
Important!
Aluminium screws/bolts must be replaced each time they are
released.
The end faces of aluminium screws/bolts are painted blue for
the purposes of reliable identification.
Jointing torque and angle of rotation must be observed
without fail (risk of damage).
Necessary preliminary tasks:
•
Remove transmission.
•
Remove clutch.
Block flywheel (1) with special tool 11 9 260 , use an old
transmission screw for this purpose.
Installation:
Replace aluminium screws.
Unfasten flywheel screws.
Tightening torque: 11 22 1AZ
.
Installation:
Flywheel (1) is secured with an alignment pin.
Fit new flywheel screws.
RA Removing and installing or replacing flywheel (N51)
BMW AG - TIS
23.02.2013 10:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
