3 Series E92 328i (N51) COUPE
•
Remove propeller shaft from transmission.
•
Release centre bearing.
•
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
Pressure line of clutch slave cylinder remains connected.
Important!
Relieve tension on clutch slave cylinder slowly; otherwise air
will be drawn in through sealing sleeve.
Release nuts (2) and remove clutch slave cylinder (1).
Tightening torque, 21 52 5AZ .
Detach locking clip.
Pull shift rod (1) out of shift rod joint (2).
Installation:
Grease shift rod pin (3).
Grease,
refer to BMW Service Operating Fluids.
RA Removing and installing transmission (GS6-17BZ) N51/N52/N52K/N53
BMW AG - TIS
23.02.2013 13:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
