3 Series E92 328i (N51) COUPE
Unlock bearing pin (1) in direction of arrow and remove.
Lift out shift arm (1).
Installation:
Grease bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Release screws.
Installation:
Tightening torque, steel screws 23 00 1AZ
.
Aluminium screws/bolts must be replaced.
Tightening torque and angle of rotation
Aluminium screws/bolts 23 00 2AZ
.
Important!
Do not suspend the transmission from the transmission input
shaft during removal and installation as this will deform the
clutch plate. Pull out transmission towards rear and remove.
Installation:
Tighten down screws/bolts to specified torque.
Secure special tool and angle of rotation 00 9 120 with magnet
00 9 130 to floor plate.
Continue to screw down blue aluminium screws/bolts in
accordance with angle of rotation.
Angle of rotation 23 00 2AZ
.
RA Removing and installing transmission (GS6-17BZ) N51/N52/N52K/N53
BMW AG - TIS
23.02.2013 13:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
