3 Series E92 328i (N52K) COUPE
11 36 655
Removing and installing/replacing both
solenoid valves (N52K)
Important!
It is essential to observe conditions of absolute cleanliness
when removing and installing the inlet and exhaust solenoid
valves.
Possible malfunction if valves are contaminated:
•
Rough running
•
OBD fault entry
•
Exhaust emission characteristics
•
Low engine power
Necessary preliminary tasks:
•
Remove ignition coil cover
Disconnect plug connection (1) on inlet solenoid valve (2).
Release screw (3).
Note:
Secure support and sealing ring against falling down.
Remove inlet solenoid valve (2) with bracket towards front.
Disconnect plug connection (6) on exhaust solenoid valve (5).
Release screw (4).
Note:
Secure support and sealing rings against falling down.
Remove exhaust solenoid valve (5) with bracket towards front.
Tightening torque 11 36 3AZ
.
Important!
Risk of mixing up plug connections (1 and 6).
Installation:
Replace support and sealing rings.
RA Removing and installing/replacing both solenoid valves (N52K)
BMW AG - TIS
02.02.2013 14:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -