3 Series E92 328i (N52K) COUPE
Note:
Grommet (3) must not be pulled out of bulkhead because this
eliminates the possibility of correct feeding in when installed.
Release screw (1).
Grip grommet (3) and pull out tension strut (2) in direction of
arrow.
Installation:
Replace screws.
Carefully feed tension strut (1) into grommet (2).
Tighten down screws to specified torque and then retighten to
angle of rotation using special tool 00 9 120 .
Tightening torque 51 71 2AZ
.
RA Removing and installing/replacing tension strut on left or right spring strut do
BMW AG - TIS
02.02.2013 23:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -