3 Series E92 328i (N52K) COUPE
![background image](/bmw/3_Series_E92/328i_N52K_COUPE/page-2021018.png)
-
Rim run-out compensation
-
With all other functions (e.g. customer input), the title illustration appears on the LCD display
Note:
If the data transmission from the remote control to the computer is interrupted, the remote control icon in the
bottom right-hand corner of the screen changes colour from green to red and the illustration on the LCD
display is shown inversely - black turns to white, white to black. This change does not take place in the title
illustration. Once the line-of-sight connection has been re-established, the remote control continues to
operate from the point of interruption in the program. A continuous visual connection during alignment is
therefore not necessary.
-
The "Hour glass" icon in the LCD display means: "Please wait".
-
The "Battery" icon in the top right-hand corner of the LCD display means that the battery reserve has
been reached.
-
To switch off the remote control: press the "F" key for 5 seconds, then return it to its charging unit or
connect it to a charge cable. The title illustration will again appear as a charging check.
-
If, during the measurement, the remote control has been placed back in the charging unit, it must be
switched on again using the "ON" button.
11. Updating the software / setpoint data
Floppy disks will no longer be sent to BMW partners who have acquired a "BMW KDS
(Beissbarth / Bosch)". For cost-related reasons, you can create these disks yourself on the
"DIS-tester" or on the "TIS/EPC server". The data for this is regularly updated on the TIS CD.
11.1 Requirements
-
BMW KDS (Beissbarth / Bosch)
-
TIS CD program status (Beissbarth): from CD 12/95
-
EPC program status: from 12/95
-
TIS CD program status (Bosch): from CD 08/97
-
DIS program status: from V6.0
-
3.5" diskettes, 1.44 MB (Beissbarth 5 diskettes / Bosch 1 diskette)
11.2 Procedure (Beissbarth)
1.
Go to the "Administration" screen
2.
Select the KDS button
3.
Select Beissbarth
4.
Insert "Diskette 1" on request and confirm with "OK" (program diskette 1 of 2 is created,
label it)
5.
Insert "Diskette 2" on request and confirm with "OK" (program diskette 2 of 2 is created,
label it)
6.
Insert "Diskette 3" on request and confirm with "OK" (setpoint data diskette 1 of 3 is created, label it)
7.
Insert "Diskette 4" on request and confirm with "OK" (setpoint data diskette 2 of 3 is created, label it)
8.
Insert "Diskette 5" on request and confirm with "OK" (setpoint data diskette 3 of 3 is created, label it)
9.
Perform update and/or setpoint data on the KDS in the usual manner with the diskettes which have just been
created.
11.3 Procedure (Bosch)
1.
Go to the "Administration" screen
2.
Select the KDS button
SBT Kinematic Diagnosis System and environment BMW KDS (Beissbarth)
BMW AG - TIS
03.02.2013 10:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 18 -