3 Series E92 328xi (N51) COUPE
Rotate crankshaft at central bolt into TDC position.
Slide in special tool 11 0 300 in direction of arrow and block
crankshaft.
Important!
On engines with automatic transmissions, there is shortly
before the special tool bore for the TDC position a large bore
which can be confused with the special tool bore.
If the flywheel is secured in the correct bore with special tool
11 0 300 , the engine can no longer be moved at the central bolt.
With 1st cylinder in firing TDC position, cams of inlet
camshaft (1) point upwards at an angle.
Part numbers (2) on twin surface of inlet and exhaust
camshafts (1) point upwards.
With 1st cylinder in firing TDC position, cams of exhaust
camshaft (3) at 6th cylinder point downwards at an angle.
Note:
If the timing is checked while the engine is installed, the position of
the camshaft can only be checked with a mirror.
RA Adjusting camshaft timing (N51)
BMW AG - TIS
04.02.2013 00:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
