3 Series E92 328xi (N51) COUPE
Turn sprocket wheel (3) at central bolt (crankshaft) into position.
Secure special tool 11 0 290 to sprocket wheel (3) and special
tool 11 4 362 .
Release screw (2).
Tightening torque: 11 66 2AZ
.
Press timing chain with chain tensioner (1) in direction of arrow.
Disconnect timing chain with special tool 11 4 120 .
Feed out sprocket wheel (3) at hexagon head of vacuum
pump (4).
Installation:
A lock pin is pre-installed if the triangular drive is replaced.
Release bolt (1) on sprocket wheel.
Tightening torque: 11 41 4AZ
.
Unfasten screws (2).
Tightening torque: 11 41 3AZ
.
Secure crankshaft and camshaft.
Do not remove special tools 11 0 300 and 11 4 280 .
Fit special tool 11 9 280 .
Release central bolt (1).
Note:
A second person is required.
RA Removing and installing/replacing chain module for oil pump/vacuum pump (N51)
BMW AG - TIS
04.02.2013 01:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -