3 Series E92 328xi (N51) COUPE
Unlock plugs (1) using slide in direction of arrow and disconnect.
Long plug:
Unlock plug on control unit and disconnect.
Unlock tab (1), pull contact carrier (2) in direction of arrow out of
housing.
Short plug:
Unlock slide (2) in bore holes (1) and pull out of housing.
Unlock tab (3), pull contact carrier (4) in direction of arrow out of
housing.
Unlock and disconnect all plug connections of engine wiring
harness section in electronics box.
Work step
Note:
Unlock plug connections on control sensors and disconnect
Unlock plug on alternator and disconnect
Unlock plug connection on knock sensors and disconnect
Unlock plug on crankshaft sensor and disconnect
Unlock plug on starter motor and disconnect
Remove rear underbody protection
Unlock plug connections on monitor sensors and disconnect
Unlock plug on oil condition sensor and disconnect
RA Replacing wiring harness section for engine (N52K, N51)
BMW AG - TIS
04.02.2013 01:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -