3 Series E92 328xi (N51) COUPE
16 11 060
Removing and installing/replacing fuel filler
pipe (US vehicles with N51 engines)
Necessary preliminary tasks:
•
Draw off fuel from fuel tank
•
Remove rear right wheel arch trim
•
Lower rear axle
Unhook retaining strap (1) from tank flap.
Open cap and set to one side.
Release hose clip (1) completely and remove clamping ring.
Installation:
Make sure that filler pipe with clamping ring is installed in
correct position.
Indentation (2) of clamping ring must line up with raised
section (3) of tank.
Pin (4) of filler pipe must line up with indentation on clamping
ring.
Hose clip (1) must always be replaced.
Tightening torque 16 11 3AZ
.
RA Removing and installing/replacing fuel filler pipe (US vehicles with N51 engines
BMW AG - TIS
04.02.2013 01:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
