3 Series E92 330xi (N52K) COUPE
Release output flange with three-claw extractor tool.
Lever radial shaft seal out of housing with a suitable tool.
Important!
Do not damage housing.
Installation:
Replace O-ring in output flange.
Check that O-ring is in correct position.
Installation:
Coat sealing lips of new radial seal with clean transmission oil.
Drive in radial shaft seal with special tool 27 1 440.
Installation:
-
Push on output flange
-
Press down output flange using 2 screwdrivers
-
Fit washer
-
Continue pressing output flange down until retaining groove
is completely visible
-
Fit retaining ring
RA Replacing radial shaft seal for output flange, automatic (ATC 300)
BMW AG - TIS
13.02.2013 00:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
