3 Series E92 330xi (N52K) COUPE
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove intake filter housing
•
Remove belt pulley
•
Remove front underbody protection
•
Remove radiator seal
Release hose clamp (1) and detach suction line (2) from vane
pump.
Installation:
Markings on suction line and vane pump connection must match
up.
Release bolt (1) and remove bracket with refrigerant line.
Release screws (2).
Installation:
Replace aluminium screws.
Observe screwing sequence!
Release banjo bolt (1) and disconnect pressure line.
Installation:
Replace all sealing rings (D).
Make sure pressure line is laid without tension and with sufficient
spacing to adjoining components.
Tightening torque 32 41 8AZ
.
Release bolts (2) and remove vane pump towards bottom.
Installation:
Replace aluminium screws.
Observe screwing sequence!
RA Removing and installing or replacing power steering vane pump (N51, N52, N53)
BMW AG - TIS
13.02.2013 02:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
