3 Series E92 335i (N54) COUPE
Important!
Note installation direction of sprocket wheel (2).
Collar on sprocket wheel (2) points to timing chain drive.
Incorrect assembly will result in engine damage.
Important!
The N54 engine requires special friction plates between the
friction surfaces.
The engine will incur damage if the plates are damaged or are
not fitted.
Friction plates (1 and 2) must be clipped into place on the oil
pump module sprocket wheel.
The third friction plate is attached to the crankshaft hub.
Feed in oil pump chain module.
Secure oil pump chain module with screws (2).
Tightening torque: 11 41 3AZ
.
Secure screw (1) with special tool 11 8 640 .
Tightening torque: 11 41 3AZ
.
Installation:
Check both friction plates (3) with retainers for correct installation
position.
Push on friction plate (1) without retainers.
Important!
The N54 engine requires special friction plates between the
friction surfaces.
The engine will incur damage if the plates are damaged or are
not fitted.
RA Removing and installing/replacing chain module for oil pump/vacuum pump (N54)
BMW AG - TIS
18.02.2013 17:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
