3 Series E92 335i (N54) COUPE
12 14 650
Replacing suction pressure sensor on intake
air manifold (N54)
Necessary preliminary tasks:
•
Read out fault memory of DME control unit
•
Switch off ignition
Note:
The installation location of the suction pressure sensor is at the
rear end of the intake air manifold.
Preparatory tasks:
•
Remove microfilter housing
Unlock plug (1) and remove.
Release screws and pull suction pressure sensor (2) out of
intake air housing.
Tightening torque 13 62 2AZ
.
Installation:
Check sealing ring for damage, replace if necessary.
When installing, coat sealing ring with suitable antiseize agent.
Note:
Check stored fault messages.
Now clear the fault memory.
RA Replacing suction pressure sensor on intake air manifold (N54)
BMW AG - TIS
18.02.2013 18:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
