3 Series E92 335i (N54) COUPE
13 71 000
Removing and installing/replacing intake filter
housing (N54)
E82, E90, E91, E92, E93 only:
Necessary preliminary tasks:
•
Remove microfilter housing
•
Remove intake duct
E60, E61 only:
Lift out expansion rivet (1).
Unclip air duct (2) from intake filter housing and remove.
Release clamp and detach air intake hose.
Tightening torque 13 71 1AZ
.
Unlock and disconnect line (1).
Unclip line (1) from air filter housing.
Release clamp and detach air intake hose.
Tightening torque 13 71 2AZ
.
Pull off wiring harness holders (1) in upward direction.
Detach intake filter housing (2) from bearings pins of rubber
mounts in upward direction and remove.
Installation:
Make sure intake filter housing rubber mounts are correctly seated
on bearing pins.
RA Removing and installing/replacing intake filter housing (N54)
BMW AG - TIS
18.02.2013 18:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
