3 Series E92 335i (N54) COUPE
Installation:
Tighten down screws/bolts to specified torque.
Secure special angle-of-rotation tool 00 9 120 with magnet
00 9 130
to underbody and screw down blue aluminium screws/bolts in
accordance with angle of rotation.
Angle of rotation 23 00 2AZ
.
Installation:
Check that dowel sleeves are correctly seated.
Replace damaged dowel sleeves.
Ensure correct position of cover plate.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, clean input shaft and replace
clutch plate.
Check clutch plate for friction rust in splines and replace if
necessary.
Mechanically remove existing grease and lining abrasion from
splines of clutch plate (with a cloth).
Installation:
Greasing specification:
-
Remove and clean release bearing and release lever.
-
Push on grease scraper ring 21 2 240 as far as it will go.
-
Grease splines (1) of input shaft with a brush. Refer to BMW
Service Operating Fluids.
-
Detach grease scraper ring.
RA Removing and installing transmission (GS6-53BZ) N54
BMW AG - TIS
18.02.2013 20:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
