3 Series E92 335i (N54) COUPE
32 41 060
Removing and installing/replacing vane pump
for power steering (N54)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove belt pulley
•
Remove left charge-air duct
•
Remove tie rod from power steering gear
Mark installation position of pressure line (arrow).
Release banjo bolt (1) and disconnect pressure line.
Installation:
Replace all sealing rings (D).
Replacement only: Carry over marking from old part.
Markings on pressure line and vane pump connection must
match up.
Tightening torque 32 41 8AZ
.
RA Removing and installing/replacing vane pump for power steering (N54)
BMW AG - TIS
18.02.2013 22:10
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
