3 Series E92 335i (N54) COUPE
33 31 000
Removing and installing complete rear axle
carrier
Warning!
Danger to life!
Mount securing fixture for vehicle on lifting platform to prevent
the vehicle from slipping off or tilting down.
Necessary preliminary tasks:
•
Mount securing fixture for vehicle on lifting platform
•
Remove both rear wheels
•
Remove propeller shaft.
•
If necessary, remove tension strut(s)
•
Remove both rear coil springs
•
Remove both pulse generators from wheel carrier, unclip line
from control arm and rear axle carrier
•
Disconnect plug connection for brake pad sensor
•
Disconnect plug connection from ride-height sensor and
unclip line from rear axle carrier
•
Disengage both handbrake Bowden cables from expander
lock and then remove from hanging hooks
•
Remove both shock absorbers from rubber mount/camber
arm
Note:
The subsequent procedure is described in the document "
Lowering/raising rear axle carrier ".
RA Removing and installing complete rear axle carrier
BMW AG - TIS
18.02.2013 22:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
