3 Series E92 335xi (N54) COUPE
First slide mounting sleeve 13 0 192 (large diameter) onto
injector (1).
Then slide mounting sleeve 13 0 193 (medium diameter) onto
injector (1).
Finally, press injector (1) into mounting sleeve
13 0 194 (small
diameter).
Installation:
Install injector within 10 minutes or slide on protective cap
(Fig. 13 14 05) (PTFE sealing ring swells up).
Installing injector:
Installation of injector is described separately from removal.
Before installing injector in engines that have been run:
•
Clean contact surfaces of uncoupling elements (2) in
cylinder head.
•
Clean injector bore: To do so, preferably slide injector without
uncoupling element (2) but with new PTFE sealing ring (1) in
and out of injector bores several times.
The PTFE sealing ring must then be replaced.
•
Replace uncoupling element (2).
RA Removing and installing or replacing an injector (N54, N53)
BMW AG - TIS
20.02.2013 06:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -