3 Series E92 335xi (N54) COUPE
34 35 003
Replacing a brake pad sensor (rear)
Important!
The brake pad wear sensor must be replaced once it has
been removed (brake pad wear sensor loses its retention
capability in the brake pad).
If a brake pad wear sensor that has already been ground has
to be replaced even though the minimum brake pad thickness
has not yet been reached, you must observe the following:
The new sliding contact must be filed down with a file to the
same length as the ground sliding contact.
Necessary preliminary tasks:
•
Remove rear right wheel
Slacken nut (1).
Pull wheel arch trim (2) gently to one side.
Disengage cable from holders (3).
Disconnect plug connection (1).
Installation:
Ensure proper locking of the plug connector and proper seating of
the cable in the brackets.
RA Replacing a brake pad sensor (rear)
BMW AG - TIS
20.02.2013 11:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -