3 Series E92 M3 (S65) COUPE
Installation:
Replace seal (1).
Align gasket (1) on cylinder head cover groove.
Press in gasket (1) so that it is free from tension.
Release park plug tube (2).
Installation:
Check rubber on spark plug tube (2) for damage; replace spark
plug tube (2) if necessary.
Apply a light coating of engine oil to spark plug tube (2) prior to
installation.
Installation:
Clean seal residue from sealing surfaces.
Coat contact surfaces of joint (1) with Drei Bond 1209 (refer
to BMW Parts Service).
Note:
Picture shows S85.
Installation:
Check decoupling element (1) for damage and replace if
necessary.
Fit cylinder head cover.
Align spark plug tubes.
Tighten down all retaining elements diagonally from inside to
outside.
Tightening torque: 11 12 8AZ
.
RA Removing and installing/sealing left cylinder head cover (S65)
BMW AG - TIS
21.02.2013 18:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -