3 Series E92 M3 (S65) COUPE
11 21 531
Replacing all crankshaft main bearings (S65)
Special tools required:
•
00 2 590
•
11 4 470
Important!
1.
Repair crankcase worn St.0 or 1 / crankshaft worn St.0.
If the bearing channel is opened and closed again after
engine operation, all main bearing shells must be
replaced with special repair bearing shells.
Altered settling behaviour at the crankcase.
Repair bearing shells are marked with an (R) on their
backs.
2.
Repair crankcase worn St.0 or 1 / crankshaft new St.0.
Repair bearing shells marked with (R) must be used.
The crankshaft comes as a set together with the bearing
shells. The bearing shells for the bedplate are provided in
accordance with the crankshaft classification. For the
crankcase bearing shells, the green bearing shells are
always provided. The half classification is retained.
3.
Repair crankcase new St.0 or 1 / crankshaft worn St.0.
The bearing shells also designated for initial installation
must be used.
The crankcase comes as a set together with the bearing
shells. The bearing shells for the crankcase are provided
in accordance with the crankcase classification. For the
bedplate, the green bearing shells are always provided.
The half classification is retained.
4.
Repair crankcase new St.0 or 1 / crankshaft new St.0.
The bearing shells also designated for initial installation
must be used.
The bearing shells provided with the crankcase must be
used.
The crankcase comes as a set together with the bearing
shells. The bearing shells for the crankcase are provided
in accordance with the crankcase classification. For the
bedplate, the green bearing shells are always provided.
The half classification is retained.
RA Replacing all crankshaft main bearings (S65)
BMW AG - TIS
21.02.2013 18:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
